Hands-on demo
Try the products yourself.
Three working demos, one for each product. They run in your browser on sample data, so nothing you type is sent anywhere.
Try this
- Enter spec limits 24.98 and 25.02 to see Cp and Cpk.
- Push part 9 above 25.02 and watch rule 1 fire.
- Open Nonconformities and raise an NCR for what the chart found.
Statistical Analysis
Clause 9.1.3Measurements
One value per part, in the order they were made.
Paste a column of numbers
Chart updated. Rule 2: nine points in a row above the center line, parts 12 to 20.
Bore diameter (mm)
Control chart · n = 20 · HV-3301 housing
- Measurement, by part number
- Flagged
- Control limits
Limits are the mean plus and minus three standard deviations, as on Kanso's SPC page.
- Mean
- 25.0016
- Center line
- UCL
- 25.0139
- Mean + 3 std dev
- LCL
- 24.9892
- Mean - 3 std dev
- Std dev (sigma)
- 0.00412
- Of all the values
Run-rule signals (Nelson)
1 finding
Rule 2: nine points in a row above the center line, parts 12 to 20. The average may have shifted. Look at what changed at the first of these parts, such as tooling or the material lot.
Next in Kanso: record this on the Nonconformities page.
Nonconformities & CAPA
Clause 8.7 / 10.2Log nonconformities. A corrective action cannot close until someone has checked that it worked.
Pick a record to see its details and move it through its status steps.
Demo on sample data. Nothing you type leaves your browser.
This is a demo on sample data. The real product connects to your own records. Read the full story
Join the Kanso waitlist